Orthodontic Research Today is a free monthly online journal that collates and summarizes the latest research about Orthodontic, including details on braces, retainers, treatment.

Comparison of wire loop and shear blade as the 2 most common methods for testing orthodontic shear bond strength.

Mojtahedzadeh F, Akhoundi MS, Noroozi H

Department of Orthodontics, Kerman School of Dentistry, Kerman, Iran. mojzad@sina.tums.ac.ir

INTRODUCTION: The purpose of this study was to compare 2 common methods of measuring orthodontic shear bond strength. METHODS: Brackets were bonded to 40 bovine incisors, and the teeth were mounted in a jig. The teeth were paired for symmetry, and the pairs were divided into 2 groups for debonding. In group 1, the shear force was applied with a rectangular wire under the tie wings. In group 2, a shearing blade applied force to the junction between the bracket base and the adhesive. RESULTS: Debonding with the shear blade produced higher (24.86 +/- 7.44 MPa) and more dispersed (coefficient of variation = 29.91%) bond strengths compared with the wire loop (17.12 +/- 3.16 MPa, coefficient of variation = 18.44%). Adhesive remnant index (ARI) scores showed a tendency for cohesive failure in the enamel in the shear-blade group (ARI = 5) compared with adhesive failure (ARI = 3) in the wire group. CONCLUSIONS: There is a need to standardize bond strength tests. The results of this study favor the wire-loop method, which might have more similarity to clinical loads. The regression formula might make comparison of previous studies easier.

Published 18 September 2006 in Am J Orthod Dentofacial Orthop, 130(3): 385-7.
Full-text of this article is available online (may require subscription).

© 2005-2008 Orthodontic Research Today. All Rights Reserved.