Orthodontic Research Today is a free monthly online journal that collates and summarizes the latest research about Orthodontic, including details on braces, retainers, treatment.

Variation in surface topography of different NiTi orthodontic archwires in various commercial fluoride-containing environments.

Huang HH

Faculty of Dentistry, School of Dentistry, National Yang-Ming University, Taipei 112, Taiwan.

OBJECTIVES: The surface topography can affect the friction behavior between an orthodontic wire and brackets during clinical applications. The purpose of this study was to investigate the influence of a fluoride-containing environment on the surface topography variations of different nickel-titanium (NiTi) orthodontic archwires. METHODS: Four different NiTi commercial orthodontic archwires were immersed in fluoride mouthwashes and in artificial saliva with the addition of commercial fluoride toothpastes or prophylactic gels for a 28-day period. Atomic force microscopy (AFM) was used to measure the three-dimensional surface topography of NiTi archwires before and after the immersion tests. Two-way analysis of variance (ANOVA) was used to analyze the surface roughness variance (including DeltaR(a), DeltaR(ms), and DeltaR(z)) with the archwire manufacturer and immersion test environment as the factors. RESULTS: Both the archwire manufacturer and immersion environment had a significant influence on DeltaR(a), DeltaR(ms), and DeltaR(z) (manufacturer: P<0.05; environment: P<0.0001). Regardless of the archwire manufacturer, no statistically significant difference in DeltaR(a) (<70nm), DeltaR(ms) (<90nm), and DeltaR(z) (<450nm) was observed on the tested NiTi archwires in lower fluoride-containing (<2500ppm) environments, including the various fluoride mouthwashes and the artificial saliva added with fluoride toothpastes. In artificial saliva added with high fluoride prophylactic gel (around 17,000ppm), a significant increase in DeltaR(a) (around 120-250nm), DeltaR(ms) (around 140-320nm), and DeltaR(z) (around 770-1410nm), i.e. increasing the surface roughness, was observed on the tested NiTi archwires. SIGNIFICANCE: The variation in the surface topography of the NiTi orthodontic archwires in the commercial fluoride-containing environments should be taken into consideration when the friction between the archwire and bracket is a clinical concern.

Published 13 December 2006 in Dent Mater, 23(1): 24-33.
Full-text of this article is available online (may require subscription).

© 2005-2008 Orthodontic Research Today. All Rights Reserved.